The developing tank elements:
The tank (1)
Has a closing strap (5) and buckle (4), contains the main light trap, which is also the fluid circulation system. The tank is printed in one piece and cannot be opened for maintenance and cleaning.
The Lid (2)
The lid contains the air vent that allows rapid loading and unloading of the tank, equipped with its small light trap. Again it is printed in one piece. Silicone gasket 90 x 2.4, replacement supplied.
A Cap (3)
The screw cap is made to size, the silicone gasket(diam 35mm x thickness 2mm) is inserted during the printing process (no user replacement).
The three frames (12)
Check them carefully for any damage or sharp edges so l that nothing can scratch the film. They are interlocking assembled and tested to slip into place without any friction.
They are available for 4×5″ and 9×12 cm format
Accessories:
Bydet (6)
Bypass-detersion system.
Replaces the lid for a film wash directly in the tank:
It distributes the water better by running it parallel to the films and has a funnel-shaped mouthpiece that aids in-sink washing.
M-buto(11)
This specially shaped funnel allows the air line to be left clear during loading. It screws onto the lid with only two turns, starting with the open end facing forward toward the liquid inlet. Nothing strictly necessary, but convenient.